
What we do
Hydraulic cylinder repair and reconditioning.
A hydraulic cylinder turns fluid pressure into a straight push or pull. When it leaks, drifts or sticks, the cause is usually a worn seal, a scored rod or a damaged bore. IKON strips the cylinder, finds the fault, repairs what can be recovered and puts it back together.

01Cylinder repair
Fault-finding first, then replacement of worn seals, damaged rods and other failed parts so the cylinder holds pressure again.
02Refurbishment
A full strip-down and rebuild: clean, inspect, replace what is worn, reassemble.
03Reconditioning
Restoring worn surfaces, such as a scored rod or bore, to working condition instead of scrapping the component.
Our expertise
What this service covers day to day
- 01
Seal replacement
New seals and wipers fitted to stop leaks and restore holding pressure.
- 02
Rod repair
Bent, scored or corroded rods repaired or replaced.
- 03
Barrel inspection
Barrels checked for scoring and wear, and restored where that is possible.
- 04
Gland and piston parts
Glands, pistons and end caps made or refitted where the originals are worn.
- 05
Full rebuilds
Complete strip-down, cleaning, inspection and reassembly.
- 06
Fault diagnosis
Finding out why a cylinder failed, so the same fault does not come back.

Frequently asked questions
Still have questions? Contact us, and our team will give you the answers you are looking for.
How do I know if my cylinder can be repaired?
If the barrel and rod can be recovered, repair is usually worthwhile. A strip-down and inspection confirms it. Deep scoring in the bore or a badly bent rod can make replacement the better choice.
What usually makes a hydraulic cylinder fail?
Contaminated oil, worn seals and side loading. Dirt in the oil scores the rod and the bore. Side loading bends the rod and wears the guides.
What are the signs that a cylinder needs attention?
Oil on the rod or around the gland, slow or jerky movement, drift under load, and loss of force.
Can you make a cylinder part that is no longer available?
Often, yes. Glands, pistons and rods can be machined from a sample or a drawing.
Should I send the whole cylinder or only the damaged part?
Send the complete cylinder with the ports capped so dirt stays out. A strip-down shows what is actually worn, and the make, bore and stroke help if you know them.
Industries
Industries that rely on this work

01 / 06
Oil & Gas
Shafts, bushings, housings and gears for pumps, valves and rotating equipment, made or repaired.
Explore
02 / 06
Marine
Bronze, brass and steel fittings, bushings and deck equipment, plus hydraulic cylinder repair.
Explore
03 / 06
Aviation
Machined and fabricated parts, and hydraulic repair, for aviation ground and workshop equipment.
Explore
04 / 06
Defense
Machining, fabrication and gear work for defense equipment, made to your specification.
Explore
05 / 06
Food Processing
Stainless steel guards, guides, brackets and gears for processing and packaging lines.
Explore
06 / 06
Manufacturing
Fixtures, tooling and spares for production equipment, from a drawing, a sample or a CAD file.
Explore
